Home › Forums › SharewareOnSale Deals Discussion › DVDFab Toolkit / Jul 19 2021
- This topic has 26 replies, 1 voice, and was last updated 3 years, 1 month ago by Gene.
-
AuthorPosts
-
AshrafKeymaster
Have something to say about DVDFab Toolkit? Say it here!
Have suggestions, comments, or need help? Post it here! If you know of better software than DVDFab Toolkit, post it here! If you know of issues with DVDFab Toolkit, post it here! Share your knowledge with all of us. :-)
Neil CronjeGuestHi, Have followed instruction and registered with DVDFab.
Downloaded and tried to install the program.
I got the following message
“The installation path is invalid”
Repeat download and installation gives same error message.
Your help will be appreciated
Thanks
NeilMiss PitaGuest[@Neil Cronje]
Same here! Took a long time to get it downloaded/registered and now I can’t install it. Very frustrating!!Bill BGuest[ @Ashraf]
I’ve downloaded it twice and same results as other 2 comments. Jump through all these convoluted steps and get nothing.fahadGuestIt was installed, but the registration process is complicated. The registration has not been completed. The program has been deleted. Thank you for the time
desertfoxGuestHave followed instruction and registered with DVDFab.
Downloaded and tried to install the program.
I got the following message
“The installation path is invalid”
Repeat download and installation gives same error message.PaulFGuest869MWPJWNZOZ is considered on the registration page as invalid code!
MarkGuestWhen I go to register the program, it says that the serial number is invalid.
Reg PellowGuestOn attempt at Registration, message received : “Invalid Serial Number”
Strega69GuestMy serial number is considered on the registration page as invalid code! :(
townie2GuestIt worked fine for me, be sure to read and follow all directions, it’s rather long and a little complicated, you do NOT use initial Serial # to register the program, but to register on their site as a member, THEN you will get program serial #
Tom SpencerGuestI Have followed instruction and registered with DVDFab.
Downloaded and tried to install the program.
I got the following message
“The installation path is invalid”
Repeat download and installation gives same error message.
Your help will be appreciatedTsvampGuestThe installer in the download kept giving me “The installation Path is invalid” After I registered I went to their site and downloaded the newest installer from there and it worked. Try that but make sure you follow the instructions on how to activate the serial. You do it through their website not the application.
pete s harrisGuestdownload path is invalid ????
SvendGuestThanks for the program!
The registration process is like breaking into Fort Knox, but I succeeded in the end.
BUT, it does not work to install on any other drive than C: as the program at startup looks for something on C: that is not there.
Had to reinstall on C. to make it work.
You should do this again. -
AuthorPosts