- This topic has 10 replies, 2 voices, and was last updated 6 years, 5 months ago by
.
-
Posts
-
Have something to say about Sketch Drawer Pro? Say it here!
Have suggestions, comments, or need help? Post it here! If you know of better software than Sketch Drawer Pro, post it here! If you know of issues with Sketch Drawer Pro, post it here! Share your knowledge with all of us. :-)
I had a previous edition of Sketch drawer and I got the offer from shareware today for Sketch drawer Pro v. 5.1 and thought it would be nice to have it and when I did the download, it deactivated my previous version and did not give me the pro version and so now I have none. :(
There is no box under any tab to enter the registration code
[ @Ashraf]
Just a reminder to folks that this seems to be version 5.1, which is the same version from years ago given away here a few times; it’s not an upgrade, so do check your existing version first.
The program (which I got here years ago, version 5.1) is quite good at what it does, so if the registration issues reported here are cleared up, I do recommend it to anyone who missed it the last few times.
The programme does not start. It gives an error message that “The code execution can not proceed because MSVCP120.dll was not found.
thank you
I’ve been a fan of this program for many years. It can make some outstanding “sketches” if you play with the settings. It does take a long time (20-60 seconds is not unusual on my PC: Win 10, i7 6700 @ 3.4GHz, GTX 750 Ti graphics card). I think the wait is not bad for what you can get.
I would like it if SoftOrbits would add a way to select a smaller region of the picture to convert for testing different settings (so it would be much faster to render that smaller region). Once it’s set the way you want, apply the settings to the whole picture.
The registration box said that hthe key entered is valid and can be activated now, but upon clicking register an error box pops up saying that the activation key does not match.
謝謝
Registration key not accepted and program runs as unregistered version.
I too am getting the same registration error message even though the key copied from the e-mail shows as being valid… In the error message is a long string of characters that I am unable to copy into this message. Therefore until this gets resolved mine is an un-registered program so I am unable to do much with it.
Please look into and advise.
Thanks.
